John Deere 9030T/9RT 30"
Camso 6500 Series (Scraper)
Durabuilt part# E30AV02954
OE Part# R545869
New - Replaces:
9030T-9RT SERIES Compatible Models:
9430T, 9530T, 9630T,
9460RT, 9470RT, 9510RT,
9520RT, 9560RT, 9570RT,
9460RT
Scraper Special,
9470RT
Scraper special,
9510RT
Scraper Special,
9520RT
Scraper special,
9560RT
Scraper Special,
9570RT
Scraper special
Technical Specifications
AVAILABLE SIZES
|
30 in (762 mm)
|
TREADBAR HEIGHT
|
2.3 in (58 mm)
|
TREADBARS
|
88
|
TREADBAR TIP WIDTH
|
3.0 in (76 mm)
|
TREADBAR PITCH
|
9.0 in (228 mm)
|
GUIDE LUGS
|
50
|
GUIDE LUG LENGTH
|
5.3 in (135 mm)
|
CARCASS THICKNESS
|
1.73 in (44 mm)
|
Camso 6500 Series (Scraper)
Built for the toughest conditions of
agricultural tractor scraper applications,
this track has specifically designed
layers of rubber on the inside
surface to provide improved puncture
resistance. This reduces the possibility
of damaging the main cables,
improving overall track life.
The Camso 6500 Series tracks utilize
the largest main cable in the industry.
The heavy duty cable is 24% larger
than the cable used in the 5500
Series tracks, making it the strongest
track in the market and best in class
track for scraper applications.
For superior track retention and
track life on sidehills, the 6500 Series
track employs longer, 5.3 in (140 mm)
guide lugs. The treadbar height is
reduced to 2.3 in (58 mm) and the
tip is widened to 3 in (76mm). The
reason for this is that in hard soil
conditions, the treadbar may not
achieve much penetration into the
surface. The drawbar load is then
transferred to the ground through the
tip of the treadbar. This may cause
the treadbar to fatigue over time
and reduce the life of the track. The
design of the treadbars reduce the
loads on the base of the treadbar,
resulting in both improved tread life
and smoother ride when operating in
scraper applications.
Track Series vs. Application Matrix
APPLICATION/OPERATION DESCRIPTION
|
Camso 6500 Series (Scraper)
|
Soil Types |
Hard packed clay |
OK to use |
Silt/loam |
OK to use |
Sticky and wet ground conditions |
OK to use |
Gumbo |
OK to use |
Rocky/Abrasive |
OK to use |
Gravel |
OK to use |
Sandy |
OK to use |
Snow/Ice |
OK to use |
Field Conditions |
Minimal ground disturbance/Berming |
Recommended |
Extreme cold |
Not recommended |
In furrow applications |
Not recommended |
Short fields, applications requiring a lot of turning |
OK to use |
Flat land farming, slopes up to 10% |
OK to use |
Moderate side slope applications, slopes from 10 to 25% |
OK to use |
Severe side slope applications, slopes greater than 25% |
OK to use |
Road Travel |
Small amount of roading, most field and travel distances within 5 mile radius |
OK to use |
Moderate amount of roading, most field and travel distances between 5 and 10 mile radius |
OK to use |
High amount of roading, typically travel in excess of 10 miles |
Not recommended |
Crop Types |
Wheat/Cereal grains |
OK to use |
Corn/Sorghum |
OK to use |
Soybeans |
OK to use |
Alfalfa/Grasses/Switchgrass |
OK to use |
Cotton |
OK to use |
Sunflowers |
OK to use |
Rice |
OK to use |
Sugarcane |
OK to use |
Sugar beets |
OK to use |
Vegetables |
OK to use |
Applications |
Primary tillage (deep ripping, chisel plow, etc |
OK to use |
Secondary tillage (field cultivator, disk, roller, etc |
OK to use |
Fully mounted roll over plow |
OK to use |
Row crop planter |
OK to use |
Air seeder |
OK to use |
Manure tank |
OK to use |
Grain cart |
OK to use |
Tile plow |
OK to use |
Spraying |
OK to use |
Hay baling |
OK to use |
Stalk chopper/Brush hog |
OK to use |
Vegetable bedder |
OK to use |
Front Blade — Silage |
Not recommended |
Forage harvestor |
Not recommended |
Snow grooming |
OK to use |
Agricultural scraper |
OK to use |
Commercial scraper |
OK to use |
Forestry |
Recommended |
Non-agricultural applications |
Recommended |