Kile® Clear View® Caps assist you by giving operators the ability to view and maintain proper oil levels of the idler and roller hubs. Clarity of oil, as well as sufficient oil, can help prevent the replacement and downtime of your equipment due to idler and roller repair.
The benefits of Kile® Clear View® Caps are:
- Ease of view of oil levels of idler & roller wheel hubs
- View clarity of oil
- Scratch resistant
- UV protected plastic
- High impact plastic protects against breakage
- Resistant to weather conditions of extreme heat or cold
- View inside and outside idlers and rollers with ease
- 5 year pro-rated warranty
Installation instructions:
MidRoller cap Installation:
Remove OEM cap.
Allow oil to completely drain.
Remove any old gasket material from face of roller hubs.
Bolt the Kile® Clear View® caps, with gaskets, to the hub and tighten bolts to 35-40 inch pounds.
Replace oil to manufacture specifications.
Install plug and tighten with plug wrench.
Idler Cap Installations: (for OEM Hub Caps) :
Remove the idler cap from hub.
Remove OEM site glass from cap by placing the cap.
Place the steel cap face up, center part #KCH3455-R over hole. Mark the cap holes & drill 5/32" holes.
Insert the pan head screw in drilled hole, turning them in half way to set the threads.
Place a roller gasket and cap on cap then fasten with two screws opposite each other. Take a dab of silicone and fill the other six locations and install screws./p>
Remove the other two screws, place a dab of silicone in each hole and replace. (This will prevent oil from leaking through screw holes). Torque all screws to 35 inch pounds.
Install idler cap, with appropriate idler gasket. Torque to 35-40 inch pounds.
Replace oil to manufacture specifications.
Install plug and tighten with plug wrench.
Use only soap and water to clean caps, no solvents (solvents can cause clouding and premature failure of caps. Solvent use will void warranty) (cite)
